Ats3b manual

This feature can also be used for general purpose remote control and annunciation and other advanced applications. All sensor and communications wiring is NEC Class 2. This simplifies installation while enhancing fire and shock safety. More sensors provides superior performance by better matching the controller to site performance requirements.

All the efficiency and controls you could ask for in a snow switch. This unit will turn on your system only when it is cold enough to snow and there is moisture detected. The gen set would not switch on from the transfer panel. John — May 1, When I had the unit installed the electrification informed me he could wire it up for auto. I had always been able to start it from the garage and place it on line. A couple of years ago I could not start it remotely garage I had to go out side and start it from inside the panel.

I contacted a company down in Jasper Ga. PSU and they sent a tech. But we need this thing to be either automatic or at least be able to start it from the garage, HELP. Admin Dale Riebel — May 9, Hi John, Yes parts are still available for that model transfer switch. It could be a defective toggle switch on the transfer switch that is keeping it from operating remotely. You can call our Service Department and we will gladly troubleshoot the issue with you.

Unfortunately, the ATS-3b was introduced in September of and after a couple batches, all had been sold So it would appear that I would miss out - and I wasn't very interested in Steve's latest ATS-4 rig because it was bigger, and heavier, and used a somewhat funky bandswitching arrangement - effective, but not what I was looking for.

The response was pretty strong, and Jim decided to enter everyone who was interested in purchasing the rig into a lottery, and my name was the one pulled out of the hat! I built an SMT dummy load kit , a Softrock SDR receiver , a crystal checker from scratch, a frequency counter, and a couple other small projects. None of these presented any problems. So, I figured it was time to start the ATS-3b! Last Friday I did a parts inventory for everything but the band boards - the manual didn't include a parts list for these, and I figured anything missing wasn't critical and could probably be subbed from my parts stash.

The inventory was OK, with the exception of having two extra resistors of one value and being short one 22k surface mount resistor. After reviewing the parts placement diagrams, it looked like the parts list was wrong and the count was fine, so I launched into soldering resistors.

The first thing I realized was that the sized resistors were a good bit smaller than the s I'd used before! Then, I got started on the sized resistors Saturday morning I got started back up and completed the resistors and inductors and went on to the capacitors. Is the suggested on out of stock? Probably has a 12 month lead time if it is.

Anyone have a spare? New or used, I don't care. Are you sure you wish to delete this message from the message archives of kd1jvdesigns groups. This cannot be undone. Cancel Yes. Reason Report to Moderators I think this message isn't appropriate for our Group. The Group moderators are responsible for maintaining their community and can address these issues.

Report to Groups. This includes: harm to minors, violence or threats, harassment or privacy invasion, impersonation or misrepresentation, fraud or phishing. Cancel Report.

Re: rig control What rig ccontrol settings would I use in Fldigi?